Operation And Usage - Meister MAS36VL Traduction Du Manuel D'utilisation Original

5450020-Akku-Schra_man 23.02.18 14:12 Seite 69
8 – Operation and usage
Inserting tools
Screwdriver bits can be inserted directly into the bit holder (8).
Switching on and off
NOTE:
Risk of damage!
If the screw is screwed into too far, there is a risk of over winding. This may
damage the cordless screwdriver and the workpiece.
Observe the screwing procedure and end the screwing process before the
screw head bites into the workpiece. Tighten the screw with a hand-held
screwdriver. Carry out tests to familiarise yourself with the operation of the
power tool.
• Switching on:
Push the On/Off switch with integrated light
switch (5).
The screwdriver starts. Hold the switch down while driving the screw.
• Switching off:
Release the On/Off switch with integrated light switch as soon as the screw
has been screwed in/out fully.
The screwdriving process is complete and the working light goes out.
• LED working light
CAUTION!
Risk of injury!
Never look directly into the light beam of the LED working light and do not
direct the light into the eyes of others. This may cause permanent damage to
eyes.
When you operate the On/Off switch with integrated light switch (5), the LED
working light will also be activated to ensure better visibility and safer
operation in darker locations. The working light goes out when the On/Off
switch is released.
69