EUROM C.U. 2000 Multi Manuel D'utilisation page 29

 The heater can be used in both the
'vertical' (buttons at the top) and the
'horizontal' (buttons at the right) positions.
In the 'horizontal' position, the heater must
rest on the grip, see the diagram. Do not
put it down flat!
 Check whether the Main switch is set to
OFF (O).
 Fully extend the power cord and plug into a
suitable 220-240V socket. To prevent the circuit overloading, check that no
other appliances are connected to the same group.
Using and Operation
Activate the heater by switching the main
switch to I (ON). You will hear a buzzing
sound and the display will show two lines. The
heater is now in standby mode.
Pressing on the ON/OFF button (1) will switch
the heater on. The red power lamp will light
up and the heater will start operating at low
power (LO). The display shows the set
temperature.
Each time you press the MODE button (2), you will switch to another function:
LO > HI > ECO >
 LO: low power (1,350 W) with thermostat operation - without sensor function
 HI: high power (2,000 W), with thermostat operation - without sensor function
 ECO sensor operation, high power with thermostat function (ECO). If the sensor
detects no-one for 5 minutes, the heater will automatically switch off (standby).
It will resume operation on its old settings if someone is detected within 2
metres of the heater. You will then hear a buzzer.
 (frost protection) The heater will try to keep the space frost-free. The
thermostat is permanently set to 7°C and the sensor will not operate.
Thermostat
The thermostat is set standard to 20 degrees. Using the Λ (3) and V (4) buttons,
you can set the thermostat higher or lower respectively: from 5 to 35°C. (Note: it
will take about a minute before the heater responds to a new temperature
setting!). Once the set temperature has been reached, the heater will switch itself
off; the fan will cool for another 30 seconds and then it too will stop. If the
temperature drops, the heater will switch itself on again. The display will continue
to show the set temperature.
(frost protection) > LO etc.
29