Sonnenkonig SECCO 200 Manuel De L'utilisateur page 63

Push Button Functions
Power Push Button
Press the button once to start operation, the default humidity level is
60%� Press it again to stop operation�
Swing push button
Press the button once to swing the air outlet louver, iIt will stop when
you press the button again�
Timer Push Button
1� Setting a start time
When the appliance is plugged in, press the Timer button first and
then press
Up/Down to set the start time�
2� Setting an end time�
3� Press the timer key and the arrow key to reset the timer�
Humidity Push Button
Press to set the desired humidity level in the room, which can be set
in the order of: 60%, 65%, 70%, 75%, 80%, 40%, 45%, 50%, 55%, 60%�
After reaching the desired humidity, both the compressor and the fan
go to standby and are activated at the time when the room humidity
exceeds the desired level of humidity�
Fan Speed Push Button
Press to set the desired fan speed� It can be adjusted between high
speed and low speed�
Up / Down button
Press the Timer button first and then press the Up/Down button to
set the time� Pressing the Up/Down button once, adds/deducts 1 hour�
Press the Humidity button first and then press the Up/Down button
to set the humidity level� Pressing the Up/Down button once, adds /
deducts 5%�
63
EN