Control Panel - Monitor Audio Gold W12 Manuel De L'utilisateur

Control Panel

3
4
5
1. Main Indicator LEDs
These LEDs show the levels and the presets selected depending on the mode being adjusted. It will
by default show the trim volume level. In normal operation, the volume trim level will be displayed
along with the Level LED (2) and numbered preset LED 1-4 (3) will be illuminated.
2. Trim Level Indicator
When just turning the control dial, the trim level is the default mode. This can be adjusted +/- 11 dB
and does not adjust the master volume control. This must be set by the SubConnect application.
3. Numbered LEDs
These are the 4 presets. Only the selected preset will be illuminated and remain illuminated whilst the
preset is in use.
4. Preset Select.
By pressing down on the control dial repeatedly to illuminate the Preset LED, the preset selection
mode is activated. Turn the dial to select the required preset. When adjusting the presets, the 7
Indicator LEDs around that preset will be illuminated.
5. Phase Adjustment.
Press down on the control dial repeatedly to illuminate the Phase LED. The phase is adjusted in 15
degree increments with the main LEDs illuminating to show the phase angle.
6. Control Dial
Use this to adjust the trim level (just turn the dial) or select from the crossover selection, phase or
presets by pressing the dial until the required feature is illuminated.
7. Crossover Adjustment
Press down on the control dial to illuminate the Crossover LED. Here you adjust the LPF crossover
frequency (when using the stereo inputs). This is adjusted in 5Hz steps from 20 to 135 Hz and is
preset to 80Hz.
1
2
monitoraudio.com
6
7
7