AmpPanel - Monitor Audio CUSTOM Serie Guide D'utilisation Du Propriétaire

AmpPanel

1
2
3
4
5
Intertek
3100294
1. Volume Control
This controls the master volume of the subwoofer. Further fine trimming can be achieved via the SubConnect application.
2. 12v Trigger - Centre Pin = +12v
For external power control from AV amplifier/ receiver to the subwoofer (cable supplied), and to toggle between different presets
depending on how it is set up in the SubConnect application. The default setting is to control the power.
This 12 volt signal comes from the source amplifier and supplies the subwoofer with a signal to perform a predetermined action.
This is either to turn it on or to switch presets. When used to turn the subwoofer on and off, it is a very energy efficient method
of power control. The auto off timer and signal sense features will not operate when the 12v trigger is connected.
3. RS232 Control
For use with home automation systems and uses a conventional RJ45 connector, refer to page 5 for the wiring configuration
and set up protocol.
4. USB-B Socket
This is provided to update the firmware and settings of the subwoofer in conjunction with the SubConnect application. The
application must be downloaded from the Monitor Audio website. A USB cable is not included, please use the appropriate
USB A - USB B cable.
2
14 13
MIN MAX 40Hz 120Hz
CUSTOM SUBWOOFER
12 11
6
10
9
8
7
7a