Command List - Monitor Audio Gold W12 Manuel De L'utilisateur

Command List

The following GET commands are used to request information from the Gold W12:
Command
Requests the Power state of the Gold
GET_O
W12 (Active/ Standby)
GET_P Requests the current Phase setting
GET_M Requests the current Mute state
GET_L Requests the current Mute Link Out state
GET_S Requests the current Preset
GET_D Requests the current Display state
GET_T Requests the current Volume Trim Level
GET_R Requests the Room EQ state
GET_N Requests the Night Mode state
The following SET commands control the operation of the Gold W12:
Command Description
SET_O:1 Go to Power On
SET_O:0 Go to Standby
Select Phase setting
SET_P:X
Where X is in the range 0 - 345
SET_M:1 Mute output
SET_M:0 Unmute output
SET_L:1 Mute Link Out output
SET_L:0 Unmute Link Out output
Select the Preset
SET_S:X
Where X is in the range 1 - 4
SET_D:1 Turn the Display on
SET_D:0 Turn the Display off
Set the Volume Trim Level
SET_T:X
Where X is in the range -11  11
SET_R:1 Turn Room EQ on
SET_R:0 Turn Room EQ off
SET_N:1 Turn Night Mode on
SET_N:0 Turn Night Mode off
11
Description
Reply from Gold W12
POWER_ON:1<CR><LF>
POWER_ON:0<CR><LF>
PHASE:X<CR><LF>
Where X is in the range 0 - 345
MUTE_ON:1<CR><LF>
MUTE_ON:0<CR><LF>
MUTE_LINK_OUT_ON:1<CR><LF>
MUTE_LINK_OUT_ON:0<CR><LF>
PRESET:X<CR><LF>
Where X is in the range 1 - 4
DISPLAY_ON:1<CR>LF>
DISPLAY_ON:0<CR>LF>
TRIM_LEVEL:X<CR><LF>
Where X is in the range -11 - 11
ROOM_EQ:1<CR><LF>
ROOM_EQ:0<CR><LF>
NIGHT_MODE:1<CR><LF>
NIGHT_MODE:0<CR><LF>
Gold W12
Reply from Gold W12
POWER_ON:X<CR><LF>
Where X is either 1 (Active) or 0 (Standby)
PHASE:X<CR><LF>
Where X is in the range 0 - 345
MUTE_ON:X<CR><LF>
Where X is either 1 (Muted) or 0 (Not Muted)
MUTE_LINK_OUT_ON:X<CR><LF>
Where X is either 1 (Link Out Muted) or 0 (Link Out Not Muted)
PRESET:X<CR><LF>
Where X is in the range 1  4
DISPLAY_ON:X<CR>LF>
Where X is either 1 (Display On) or 0 (Display Off)
TRIM_LEVEL:X<CR><LF>
Where X is in the range -11 - 11
ROOM_EQ:X<CR><LF>
Where X is either 1 (Room EQ On) or 0 (Room EQ Off)
NIGHT_MODE:X<CR><LF>
Where X is either 1 (Night Mode On) or 0 (Night Mode Off)