Using Subconnect For Room Correction; Recommended Settings For Av Systems; Recommended Settings For Stereo - Monitor Audio Gold W12 Manuel De L'utilisateur

NOTE
If the sweep is run without the microphone
connected an error code will be displayed,
illuminating ALL LEDs. To reset it from this error
state, just turn the dial.
Using SubConnect for Room
Correction
To run the room correction on the SubConnect
application, follow the steps below. For information on
installing the application please refer to the next page.
1. With the Gold W12 switched on and
connected to the PC by USB cable, open the
SubConnect app on your PC and click on
Tools > Room Correction
2. Select the number of cycles you wish to run
(default is 2) and then click on the RUN button.
The sweeps will start as soon as the RUN
button is pressed. There will be a pause of
around 20 seconds between sweeps.
Recommended Settings for AV
Systems
When using the Gold W12 in an AV system, it
is recommended to use Presets 2 (Movies) or 4
(Impact) as the starting points. You can then, if you
wish, tweak these slightly to get it sounding just
how you want in your room. For advice on adjusting
the EQ settings. When using the LFE input, the
crossover adjustment feature will not work.
NOTE
If any adjustments are made by the Control Dial,
they will only be remembered if the sub is left to
turn off automatically or put into standby by the
remote. If the mains switch on the amp is turned
off or the power removed from the sub woofer, it
will not remember the settings.
Recommended Settings for
Stereo
When using the Gold W12 in a stereo system, it is
recommended to use Presets 1 (Music) or 3 (Flat)
as the starting points. You can then, if you wish,
tweak these slightly to get it sounding just how you
want in your room. Once the preset is selected,
adjust the crossover frequency so that it blends in
seamlessly with your main speakers. This may take
some adjustment and the playing of various pieces
of familiar music to get it sounding perfect.
NOTE
If any adjustments are made by the Control Dial,
they will only be remembered if the sub is left to
turn off automatically or put into standby by the
remote. If the mains switch on the amp is turned
off or the power removed from the sub woofer, it
will not remember the settings.
monitoraudio.com 9