Manual Update - Monitor Audio Gold W12 Manuel De L'utilisateur

Manual Update

If the automatic update doesn't work, or you wish
to manually check for an update, open the app
and with the Gold W12 on and connected, click on
Tools > Firmware Update.
1. Click check for update. If the Gold W12 is up
to date, you will be informed, likewise, if there
is an update available for it you will also be
informed.
2. If it isn't already, you will receive a prompt
asking for the Gold W12 to be put into
Bootloader mode. For information on how
to do this refer to Bootloader Mode section.
Follow these steps and when you have re-
established connection to the Gold W12 click
on Tools > Firmware Update again and you will
see a new prompt. Click on Update.
3. A progress bar will now be displayed showing
the status of the update.
4. When it is complete you will receive
confirmation and the sub woofer will reboot
(when you click on OK). If there is a signal
going into the sub woofer, it will automatically
start up. If there is no signal, the sub woofer
will need to be woken up.
monitoraudio.com 13