Positioning; Spiked Foot Fixing For Carpeted Floors - Monitor Audio Gold W12 Manuel De L'utilisateur

IMPORTANT!
To achieve the very best from your subwoofer and to be able to gain access to the
advanced settings and firmware updates, please download the SubConnect PC
application from our website. Included within this download are full instructions of which
functions can be adjusted using the SubConnect application.

Positioning

The Gold W12 should be sited in the most suitable position, preferably not directly in the corner of a room
as this may cause excessive bass boom. The optimal position is along the front wall in the centre of the
front left and right speakers. Obviously this isn't always going to be possible in all instances, so as close
to the optimum is advisable. Once a desirable position is achieved it is important to check if the cables are
long enough to reach comfortably without being under tension. Leave the Gold W12 unplugged until you
are happy with its location and the feet have been fitted.
Never connect or disconnect any of the input connections with the Gold W12 switched on.
Once in position, you should fit the feet/ spike assemblies in accordance with the guidelines below. Once
the feet have been fitted, connect the signal cable(s) and mains cable and turn on at the main switch.

Spiked Foot Fixing For Carpeted Floors

The spiked foot assembly incorporates a spike for use on carpeted floors and also, a soft polymer pad (for
use on wooden or tiled floors).
Please ensure there are no hidden wires under the carpet, or trailing mains leads that could be damaged by
the spikes.
The foot comes fully assembled for use on carpeted floors. All that is required is fixing into the cabinet. This
is achieved by simply screwing the feet fully into the 4, threaded inserts in the underside of the cabinet. If
your carpet has a very thick pile, remove the soft polymer pad from the foot to ensure the spike goes right
through the carpet onto the floor. With great care turn your cabinet the right way up. Place the cabinet in
your desired location, and check that it is level on all sides. If it is slightly uneven, unscrew the foot at the
lowest point and check again. Continue this process until the cabinet is fully level. Use the locking nut on
the foot to fix it in place and to stop any unwanted vibrations.
Spiked Foot Fixing For Wooden/Hard Floors
For use on solid floors or where spikes are inappropriate, it is possible to use the foot without the spike
insert. To use the foot in this manner carefully grip the knurled portion of the spike and rotate anti clockwise
to unscrew the spike fully.
You may find it easier to first remove the polymer pad to gain more purchase on the spike.
The pad should be replaced before carrying out the leveling operation previously described.
monitoraudio.com 3