Introduction; Safety Messages; Improper Use Of The Welding And Power Supply Cables; Securing The Fitting And The Joint - Rothenberger ROWELD ROFUSE Sani 160 Instructions D'utilisation

1

Introduction

Dear Customer,
Thank you very much for purchasing our product. We are confident that it will meet your
expectations. The ROWELD ROFUSE Sani 160 Electrofusion Welding Unit is designed
exclusively for jointing PE discharge lines assembled with electrofusion fittings.
The product was manufactured and checked according to state-of-the-art technology and
widely recognized safety regulations and is equipped with the appropriate safety features.
Before shipment, it was checked for operation reliability and safety.
In the event of errors of handling or misuse, however, the following may be exposed to
hazards
• the operator's health,
• the product and other hardware of the operator,
• the efficient work of the product.
All persons involved in the installation, operation, maintenance, and service of the product
have to
• be properly qualified,
• operate the product only when observed,
• read carefully and conform to the User's Manual before working with the product.
Thank you.
2

Safety Messages

This device is not intended for use by children and persons
with physical, sensory or mental limitations or a lack of experi-
ence or knowledge. This device can be used by children aged 8
and above and by persons who have physical, sensory or men-
tal limitations or a lack of experience or knowledge if a person
responsible for their safety supervises them or has instructed
them in the safe operation of the device and they understand
the associated dangers. Otherwise, there is a danger of operating
errors and injuries.
Supervise children during use, cleaning and maintenance. This
will ensure that children do not play with the device.
2.1

Improper Use of the Welding and Power Supply Cables

Do not carry the product by one of its cables and do not pull the power cord to unplug the unit
from the socket. Protect the cables against heat, oil, and cutting edges.
2.2

Securing the Fitting and the Joint

Use appropriate clamps to secure the fitting and the joint before welding. The welding unit is
intnded exclusively for indoor installation applications. Use for buried pipeline construction
applications is prohibited.
2.3

Cleaning the Welding Unit

The preoduct must not be sprayed with or immersed in water.
2.4

Opening the Unit

The cover of the product may be removed only by specialized staff of the
company ROTHENBERGER or of a partner organization properly trained and
approved by it!
2.5

Checking for Damage

Every time before operating the product, carefully check safety features or possibly existing
parts with minor damage for intended and proper function work properly, that contact is fully
established, and that the contact surfaces are clean. All parts have to be installed correctly
ENGLISH 7