Publicité
Les langues disponibles
Les langues disponibles
V3.5
MAINTENANCE
1.
Maintain the tool with care. A tool in good condition is efficient, easier to control and will have
fewer problems.
2.
Inspect the tool components periodically. Repair or replace damaged or worn components.
3.
Follow instructions for lubricating and changing accessories.
4.
Keep the tool handles clean, dry and free from oil/grease at all times.
5.
When servicing, use only identical replacement parts. Only use accessories intended for use with this tool.
Replace damaged parts immediately.
6.
The oil level should be kept constant at about 1-1/4 quarts of quality hydraulic oil. Too much oil will force
the surplus oil to leak from the cylinder seals and possible damage them. Not enough oil will cause loss of
power as air will be sucked in, causing a drop in pressure.
7.
Periodically clean and maintain the machine. Use clean, filtered oil, making sure the filter (#30) is
cleaned regularly.
WARNING! Hydraulic fluid is under extreme pressure when the ram is
under pressure. Always relieve the pressure with the release valve
before removing the vented oil bolt (Fig. 6)
NOTICE! The oil bolt is internally vented and cannot be replaced with a
regular hex bolt. You must replace it with another vented bolt. Normal
hex bolts will block the flow of hydraulic fluid and cause the machine
to fail.
WARNING! Only qualified service personnel should repair the tool.
An improperly repaired tool may present a hazard to the user
and/or others.
LUBRICATION
Inspect and lubricate the tool when required.
STORAGE
When not in use for an extended period, apply a thin coat of lubricant to the steel parts to avoid rust. Remove the
lubricant before using the tool again.
DISPOSAL
Recycle a tool damaged beyond repair at the appropriate facility.
Contact your local municipality for a list of disposal facilities or by-laws for electronic devices, batteries, oil or
other toxic liquids.
DISPOSAL OF HYDRAULIC FLUID
Do not drain hydraulic oil into the sewer system or dispose in an uncontrolled location. Hydraulic fluid may take
up to a year to breakdown in the environment and the ingredients may still be toxic. Contact your local
municipality for proper disposal instructions or locations.
Visit www.princessauto.com for more information
Hydraulic Pipe Bender with Tripod
8524290
Fig. 6
7
Publicité
