Publicité
Les langues disponibles
Les langues disponibles
8524290
SPECIFIC SAFETY PRECAUTIONS
1.
Check that there is enough oil in the tank to operate the pipe bender.
2.
Loosen the vented oil bolt to ventilate.
3.
Close the release valve before bending any pipe
4.
The outside pipe diameter must fit the bending die's groove. A mismatched may damage or shatter the
pipe die when under pressure.
5.
The contact surface between tube and the two swaging blocks must be smooth. Coat swaging blocks with
lubricating oil.
6.
Make sure a weld seam is not at the bending point.
7.
Excessive pressure can damage the pipe bender. Do not exceed the working pressure (see Specifications).
8.
Tighten the vented oil bolt when finished using the machine.
GENERAL SAFETY PRECAUTIONS
HYDRAULIC SAFETY
IMPORTANT! Seek immediate, professional medical treatment if hydraulic fluid penetrates the skin. Do not
wait for the appearance of symptoms. An infection or toxic reaction may occur from the exposure.
1.
The hydraulic components require regular inspection. Replace damaged hydraulic parts with the same
manufacturer's components.
2.
Do not attempt makeshift repairs to a hydraulic system. Such repairs can fail suddenly and create a
hazardous condition.
3.
Use wood or cardboard as a backstop instead of hands.
4.
Always ensure the hydraulic device is on a hard, flat and level surface while in use.
5.
Never exceed the load capacity of the hydraulic device (see Specifications).
6.
Do not adjust relief setting of hydraulic system except as instructed.
7.
Escaping hydraulic fluid under pressure may have sufficient force to penetrate the skin.
a.
Always check for leaks wearing a face shield or safety goggles.
b.
Wear rubberized gloves.
c.
Wear protective clothes.
d.
Do not use your hands to detect a leak. Use a piece of cardboard or paper and watch for
discolouration to find a hydraulic fluid leak.
USE AND CARE OF THE TOOL
1.
Use the correct tool for the job. This tool was designed for a specific function. Do not modify or alter this
tool or use it for an unintended purpose.
2.
Remove adjusting keys and wrenches from the tool before operation.
4
Hydraulic Pipe Bender with Tripod
For technical questions call 1-800-665-8685
V3.5
Publicité
