Transportation; Crane Transport; Operation; Setup - WAGNER HC730 (GAS) Mode D'emploi

HeavyCoat
3.6

TRANSPORTATION

Do not lift by cart handle when loading or
unloading.
Device is very heavy. Three-person lift is required.
Attention
TRANSPORTATION IN VEHICLE
Secure the unit with a suitable fastening.
PUSHING OR PULLING THE UNIT
Pull out the handle (Fig. 4, Item 1) until it will come no further.
Insert the handle – push the buttons (2) on the cart, and then
push in the handle.
3.7

CRANE TRANSPORT

Hanging points for crane straps or ropes, see figure 5.
4
4.1
1. Make sure the bleed hose (Fig. 6, item 1) is threaded into
the bleed valve (2). It has factory installed PTFE tape on
the fitting and should be tightened wrench tight.
2. Attach a minimum of 50' (15 m) of nylon airless spray hose
(3) to the sprayer. Do not use PTFE tape or thread sealant
on the spray hose connection.
1
2
3. Attach an airless spray gun to the spray hose. Do not
attach the tip to the spray gun yet. Remove the tip if it is
already attached.
i

OPERATION

This equipment produces a fluid stream at
extremely high pressure. Read and understand
the warnings in the Safety Precautions section
at the front of this manual before operating this
equipment.

SETUP

For multiple gun operation, connect a multiple
gun manifold to the single gun outlet. Connect
a hose and gun to each outlet.
the second gun outlet remains plugged. See
"Technical Data", Section 3.5 to determine
number of guns and maximum spray tip sizes.
DESCRIPTION OF UNIT / OPERATION
2
1
3
Make sure
13