Connecting The Device; Device Operation - Expondo S-SPOTTER 4000 Manuel D'utilisation

Assemble the included trolley in accordance with the overview diagram.

4.3 CONNECTING THE DEVICE

The machines is powered by two phase 400 V alternating current. Plug connection diagram:
not connected
connected
L3 L2
L1
N
not connected
connected
PE
connected
4.3.1 CONNECTION OF EARTHING
1 2
1. Weld 2 washers on a metal work surface as close as possible.
2. Connect the washers with a wire.
3. Apply a metal lock to the washers.
4. Insert locking bolt.
5. Tighten the lock.

4.4 DEVICE OPERATION

4.4.1 WELDING WASHERS
Connect the earth cable to a clean, unpainted work surface, near the welding spot. Connect the adapter for
washers to the gun, then insert a washer. Set the required welding current.
18
The green-yellow wire is used to connect the
PE earthing cable. The two phases should be
connected to L1 and L2. Phase three L3 and
neutral N connections remain unconnected
in the plug. A qualified electrician is required
to perform these connections.
5
3
4
Rev. 30.05.2017
Set the welding time. Align the gun with the surface at a 90°C angle, then apply pressure to the gun and
press the trigger. Remove the gun. Use the hammer to remove a welded washer: insert the hammer hook
through the washer eye and move the hammer handle quickly towards you.
4.4.2 WELDING TRIANGULAR WASHERS
Connect the earth cable to a clean, unpainted work surface, near to the welding spot. Connect the adapter
for triangular washers to the gun, then insert a washer. Set the required welding current.
Set the welding time. Align the gun with the surface at a 90°C angle, then apply pressure to the gun and press
the trigger. Remove the gun. Use the hammer to remove a welded washer: insert the hammer hook through
the washer eye and move the hammer handle quickly towards you.
4.4.3 CARBON ROD HEATING UP
Connect the earth cable to a clean, unpainted work surface, near to the welding spot. Connect the carbon
rod and the adapter to the gun. Set the required welding current.
Rev. 30.05.2017
19