Cleaning And Maintenance - Expondo S-SPOTTER 4000 Manuel D'utilisation

Set the welding time. To heat up sheet metal, rotate the carbon rod clockwise. Use cold water or a wet cloth
to cool down the hot surface. This will cause the sheet metal to shrink back to its normal state.
4.4.4 WELDING ZIGZAG WIRE
Connect the earth cable to a clean, unpainted work surface, near to the welding spot. Connect an
appropriate electrode. Set the required welding current.
Set the welding time. Align the zigzag wire with the work surface, align the gun at a 90°C angle, then apply
pressure to the gun and press the trigger. Connect the hook to the hammer, quickly move the hammer
handle to "pull out" the dent.
ATTENTION! The device is protected against overheating, during operation the device may switch off
and activate its fans to cool down. Refrain from using the device for 15 minutes until it cools down. If this
occurs frequently reduce the welding current and / or the welding time.
ATTENTION! To prevent damaging the work surface, test the operation of the device on a different
piece of metal (with the same properties) to adjust the welding current and time.
4.4.5 WORKING WITH THE SUCTION PAD
Connect the suction pad to the hammer, press down on the
suction pad so that it attaches to a surface and then move the
hammer handle quickly towards yourself.
20
5. DISPOSING OF PACKAGING
The various items used for packaging (cardboard, plastic straps, polyurethane foam) should be kept, so that
the device can be sent back to the service centre in the best possible condition in case of any problems!
6. TRANSPORTATION AND STORAGE
Shaking, crashing and turning upside down of the device should be prevented when it is transported. Store it
in a properly ventilated surrounding with dry air and without any corrosive gas.

7. CLEANING AND MAINTENANCE

• Always unplug the device before cleaning it and when the device is not in use.
• Use cleaner without corrosive substances to clean surface.
• Dry all parts well before the device is used again.
• Store the unit in a dry, cool place, free from moisture and direct exposure to sunlight.
8. CHECK REGULARLY THE DEVICE
Check regularly that the device doesn ́ t present any damage. If there is any damage, please stop using the
device. Please contact your customer service to solve the problem.
What to do in case of a problem?
Please contact your customer service and prepare following information:
• Invoice number and serial number (the latter is to be found on the technical plate on the device).
• If relevant, take a picture of the damaged, broken or defective part.
• It will be easier for your customer service clerk to determine the source of the problem if you give
a detailed and precise description of the matter. The more detailed your information, the better the
customer service will be able to answer your problem rapidly and efficiently!
CAUTION: Never open the device without the authorization of your customer service. This can lead to
a loss of warranty!
Rev. 30.05.2017 Rev. 30.05.2017
21