Expondo S-SPOTTER 4000 Manuel D'utilisation page 9

PLEASE NOTE: THE DEVICE MAY ONLY BE USED UPON CONNECTION TO AN
INSTALLMENT WITH A PROPERLY FUNCTIONING FUSE!
4. OPERATION
4.1 MACHINE DESCRIPTION
S-SPOTTER 4000 / S-SPOTTER 4200
1
4
2
3
5 6 7
Operation
In Auto mode: Adjust the welding time using knob number 4, adjustment range: 0.2 s to 2 s. Adjust the power
using the knob: A - low power, B - medium, power, C - full power.
In Manual mode does not matter what time is set. Device work, when button on welding gun in ON.
S-SPOTTER 5000
10
11
1 2
12
13
3 4 5 6
14
15
7 8 9
16
Description of the operating program
The device includes pre-set programmes. This speeds up the selection of appropriate working parameters.
16
1. Welding voltage display
2. Current adjustment knob
3. Mode change Auto/Manual
4. Time adjustment knob
5. Main ON/OFF switch
6. Ground out
7. Gun out
1. Time display
2. Device power % display
3. Button for setting tome "-"
4. Button for setting tome "+"
5. Button for setting power "-"
6. Button for setting power "+"
7. Programme selector
8. Automatic / manual selector
9. Program selection conformation
10. Power on indicator
11. Overheat indicator
12. Manual operation indicator
13. Automatic operation indicator
14. Welding gun welding on indicator
17
15. Confirmation indicator
16. Gun lead out
17. Ground out
Rev. 30.05.2017
Component elements (may vary from depending on the model).
3
4
5
1
1. Working handle (gun)
2. Carbon arc nozzle
3. Nozzle for washers
4. Nozzle for bolts, pins, etc.
5. Electrode for one sided welding
6. Electrode with a flat pin for welding zigzag wires
7. Hammer with a nozzle for welding washers / hook for pulling dents
4.2 DEVICE OPERATING MODES
Program Function Description
A Welding triangular washers
B, C Welding washers
D Welding pins/bolts etc.
E Welding bolts
F Zigzag wire welding
G Sheet metal overlap welding
H Swelling – hearing up sheet metal
using a carbon arc
I Sheet metal overlap welding
J Carbon arc cutting
Once the required programme has been selected using the button number 8 on the control panel
(programme selection), or the welding time and power have been selected manually, press the button
confirming the programme selection (number 8). Then the parameter change functions will be locked and
you may begin working. In order to be able to make changes to the operating parameters, press button
number 8 again.
Rev. 30.05.2017
2
6
7
Power % setting Time range
23-100 001 – 999 <FFF
23-100 001 – 999 <FFF
23-100 001 – 999 <FFF
23-100 001 – 999 <FFF
23-100 001 – 999 <FFF
23-100 001 – 999 <FFF
23-100 001 – 999 <FFF
23-100 001 – 999 <FFF
23-100 001 – 999 <FFF
17