dji T30 Guide De L'utilisateur page 13

Using DJI Assistant 2 for MG
1. Download DJI Assistant 2 for MG at https://www.dji.com/t30/downloads or https://www.dji.com/
t10/downloads.
2. Launch DJI Assistant 2 for MG and log in with your DJI account.
3. Power on the battery station and connect the station to a computer via the USB-C port.
4. Select "Battery Station / Inverter Generator" and click on Firmware Updates on the left panel.
5. Select the firmware version that you wish to update to.
6. Wait for the firmware to download. The firmware update will start automatically.
7. The station will reboot automatically after the firmware update is complete.
Before using the battery station, make sure there are no obvious defects on the ports or
cables of the battery station (e.g., jams, breakages, or short circuits).
DO NOT connect the batteries while updating the firmware of the battery station.
DO NOT disconnect the battery station while updating the firmware of the battery station.
Make sure the computer is connected to the internet.
Retry if update fails.
Storage and Maintenance
Battery Station Storage
When the battery station is not in use, disconnect the batteries from the battery station and the
battery station from the power outlet. Follow the steps below to safely secure the charging cables.
1. After disconnecting a battery, wrap the charging cable over the battery station.
2. Make sure the end of the charging cable is securely attached to the corresponding storage on
the side of the battery station.
DO NOT store this product under direct sunlight, in rain, or in a damp environment.
Keep the battery station away from heat, pressure, water, flammable gases, and
corrosives.
©
2021 DJI All Rights Reserved. 11