Depaepe PXB41A Notice D'utilisation page 22

SecurAccess SIP Basic Line – User Guide
DTMF Payload Type
DTMF Type
Send Flash event
Enable Call Feature
Proxy Require
Use NAT IP
SRTP Mode
VAD
Symmetric RTP
Jitter Buffer Type
Jitter Buffer Lengh
Account Ring Tone
Ring Timeout
Dial Plan
Subscribe for MWI
This parameter sets the payload type for DTMF using RFC2833.
Send DTMF as inband (in-audio), via RTP (According to RFC 2833), or
via SIP INFO message.
This parameter allows users to control whether to send an SIP NOTIFY
message indicating the Flash event, or just to switch to the voice
channel when users press the Flash key.
Default is No.
If set to Yes, Call Forwarding & Do-Not-Disturb are supported locally
(see P.17)
if Yes, call features using star codes will be supported locally
SIP Extension to notify SIP server that the unit is behind the
NAT/Firewall.
NAT IP address used in SIP/SDP message. Default is blank.
Secure Real-Time Transport Protocol (SRTP) encrypts the RTP during
VoIP phone.
Default is No. VAD allows detecting the absence of audio and conserve
bandwidth by preventing the transmission of "silent packets" over the
network.
Default is No. When set to Yes the device will change the destination
to send RTP packets to the source IP address and port of the inbound
RTP packet last received by the device.
Select either Fixed or Adaptive based on network conditions.
Select Low, Medium or High based on network conditions.
There are 8 uniquely defined ring tones.
Incoming call will stop ringing when not picked up given a specific
period of time.
Dial Plan Rules:-
1. Accept Digits: 1,2,3,4,5,6,7,8,9,0
2. Grammar: x - any digit from 0-9;
a. xx+ - at least 2 digit number;
b. ^ - exclude;
c. [3-5] - any digit of 3, 4, or 5;
d. [147] - any digit 1, 4, or 7;
e. <2=011> - replace digit 2 with 011 when dialing
• Example 1: {[369]11 | 1617xxxxxxx} –
Allow 311, 611, 911, and any 10 digit numbers of leading digits 1617
• Example 2: {^1900x+ | <=1617>xxxxxxx} –
Block any number of leading digits 1900 and add prefix 1617 for any
dialed 7 digit numbers
• Example 3: {1xxx[2-9]xxxxxx | <2=011>x+} –
Allow any length of number with leading digit 2 and 10 digit-numbers
of
leading digit 1 and leading exchange number between 2 and 9; If
leading
digit is 2, replace leading digit 2 with 011 before dialing
3. Default: Outgoing - {x+}
Default is No.
22