Depaepe PXB41A Notice D'utilisation page 18

SecurAccess SIP Basic Line – User Guide
User ID is Phone Number
SIP Registration
Unregister On Reboot
Register Expiration
Outgoing call without
registration
Local SIP Port
Use Random port
Voice Mail User ID
RPort
RFC 2543 Hold
If the SecurHD IP has an assigned PSTN telephone number, this
field should be set to "Yes". Otherwise, set it to "No".
If "Yes" is set, a "user=phone" parameter will be attached to the
"From" header in SIP request.
This parameter controls whether the SecurHD IP needs to send
REGISTER messages to the proxy server.
The default setting is "Yes".
Default is "No."
If set to "Yes", then the SIP user will be unregistered on reboot.
This parameter allows the user to specify the time frequency (in
minutes) the SecurHD IP refreshes its registration with the specified
registrar.
The default interval is 60 minutes (or 1 hour).
The maximum interval is 65535 minutes (about 45 days).
Default is No.
If set to "Yes," user can place outgoing calls even when not
registered (if allowed by ITSP) but is unable to receive incoming
calls.
This parameter defines the local SIP port the SecurHD IP will listen
and transmit.
The default value for FXS port is 5060.
The default value for FXO port is 5062.
This parameter, when set to Yes, will force random generation of
both the local SIP and RTP ports. This is usually necessary when
multiple SecurHD IP are behind the same NAT.
The number for check voice mail.
RPort in RFC 3581.
By default is Yes. Enable if Yes or disable if No : Hold
18