Removing And Replacing The Rear Wheel - Sherco SE 4.5if Manuel Du Propriétaire

REMOVING AND REPLACING THE REAR WHEEL

2
1
3
88
To remove the rear wheel
- Unscrew nut 1 and remove the sliding
part 2
- Tap the axle 3 with a nylon mallet
- Remove it,
- Move the wheel as far forward as
possible
- Remove the chain and the wheel.
To replace the rear wheel
- Reverse the procedure, greasing the
axle, with grease.
- Degrease the disc with solvent Brake
cleaner
- Prime the brake
Check and make sure that you have pro-
perly tightened the rear axle by ushing
it forward.
Torque
Refer to table page 95
WARNING
NOTE