Sherco SE 4.5if Manuel Du Propriétaire page 62

Fig2 TOTAL function
Fig3 TD function
60
Total distance function
This function describes the function/
display of the total distance traveled.
The information depending on the unit
of measurement selected, the figure
is shown in kilometres (default value)
or miles. In normal conditions of use
of the instrument, it is not possible to
zero this information. The maximum
figure that can be displayed is 99,999
km. (or miles); once this is exceeded,
the counter is reset to zero. The figure
shown increases by integer values of 1
km. /mile.
TRIP function automatic TD
This function describes the function/dis-
play of the unit's automatic trip function
; the figure shown represents the dis-
tance run by the bike expressed in kilo-
metres or miles (depending on the unit
of measurement selected), with a reso-
lution of 0.1 (kilometres or miles); this
counter is automatic: it is activated by
the first impulse from the speed sensor.
The figure is not saved permanently. It
is possible to zero the counter associa-
ted with this parameter by pressing the
button (below the TD function) for about
3 seconds until the value 000.0 appears.
The zeroing of the TD can be effected
both while stationary and whilst moving,
and also zeroes the LAP function. If the
figure exceeds 999.9, the system will
automatically zero the TD and LAP, and
will then restart the trip.