Sherco SE 4.5if Manuel Du Propriétaire page 64

TRIP function
Automatic trip Countdown
This function describes the function/dis-
play of the unit's countdown trip func-
tion. The counter is always active and
counts down with a resolution of 0.1
(kilometres or miles depending on the
unit of measurement selected).
It is possible to modify the value asso-
ciated with this parameter by pressing
Fig7 Trip functon the button (below the TD function and
whilst stationary) for about 3 seconds
until only the segments relative to the
countdown function and the letters TD
(still flashing) are active, while all the
other segments are switched off, as
shown in Fig.8
It is possible to modify the different
figures in the counter, starting with the
Fig8 Parameter countdown function. largest figure and moving successively
to the lesser one; depending on the data
selected (shown flashing with f=1Hz,
Duty=50%), a brief pressure on the
button will decrease the figure by one,
while a longer pressure will enable the
selection of a different parameter.
Once the adjustment has been finished,
normal operation mode is activated by
pressing the button for about 3 seconds
while the lesser figure is selected. If the
figure counts down to 000.0, the system
will Re-initialize the value at 999.9.
62