Publicité
Les langues disponibles
Les langues disponibles
PRESCRIPTIONS
Accident prevention
The product shall be used by qualified personnel only.
Do not use the equipment in case it is damaged. Apply to your retailer.
Avoid precarious repairs. Repairs shall be carried out with original spare parts only, which
shall be installed according to the intended use.
Since the product is made of corrosion-proof materials suitable for the enviromental conditions foreseen for
its normal use, does not require special care, however it is necessary to store it in a closed place making
sure that is protected from dust and dirt to assure its hygenic conditions. Moreover, it is recommended to
store the product in a place which can be reached easily by the personnel in case of necessity.
TRANSPORT
Transport procedures
It is not necessary to follow particular transport procedures. It is however recommended to carefully
handle it and avoid shocks. The equipment is delivered in an imitation leather case allowing a comfortable
shoulder transport.
Unpacking
Always remember that packing elements (paper, cellophane, stitches, adhesive tape, etc.)
can cut and/or hurt if they are not carefully handled.
They shall be removed with adequate means and shall not be left at the mercy of irresponsible
persons; the same is valid for tools used to remove packages (scissors, knives, etc.).
After opening the packages, first of all it is necessary to check all pieces and parts composing the product.
Check that they are all present and in perfect conditions.
INSTALLATION
Installation and connections
The pulse oximeter is delivered with the following components: a practical imitation leather case, 4 "AA"
alkaline batteries, AC adapter with 6 V output, 600 mmA, a finger sensor for heart beat survey.
To feed the equipment with 4 "AA" batteries, open the apposite compartment on the back and insert the
batteries. Pay attention not to invert the direction of poles (see the picture inside the battery compartment)
and then replace the cover.
To feed the equipment with an AC adapter, insert the adapter jack into the corresponding socket on the
equipment base and plug in the adapter.
With the exception of rechargeable batteries, remove common or alkaline batteries when
using the AC adapter for charging.
Insert the finger sensor connector into the pulse oximeter (when the sensor is not inserted, the display
views the following writing: Prb). It is sufficient to make the grooves present on the connector and on
the socket match.
How to install paper roll
1) Press the power button to turn on the appliance
2) Use finger to pull out the paper cover
3) Unroll the paper roll, make sure the paper is flat and smooth
4) Firmly insert the paper roll toward the inside of the gap
5) In the mean time, press FEED button to make sure the paper roll over outside of the cover in the
right position
6) Then close up the paper cover
ENGLISH
10
Publicité
