Connections For A Multi-Camera System - Sony DXC-950P Mode D'emploi

Basic System Connection

Connections for a Multi-Camera System

Notes on multi-camera systems
Take the following steps to prevent flicker when switching
between two or more cameras connected to a video switcher:
• Supply the same sync signal to the GEN LOCK
connectors on each camera (see below).
Sync signal
generator or camera
Sync (VBS or
BS) output
VIDEO IN
VBS (BS) OUT
Video monitor, VCR, etc.
Note
Before connecting video equipment, see "Important safeguards/notices for use in the medical environments" on page 5.
24
DXC-950P
VIDEO OUT
75Ω coaxial cable
VBS (BS) OUT
Video switcher, etc.
VIDEO IN
VIDEO OUT
75Ω coaxial cable
• Adjust the subcarrier and horizontal synchronization
phases for all cameras.
For more details, see "Adjusting the Picture Tone in a
Multi-Camera System" on page 52.
DC IN/
MENU FUNCTION DATA
FLASH UP LENS
WHITE
BARS
DOWN
REMOTE
CCU
RGB/SYNC
VIDEO OUT REMOTE
DC IN/ GEN LOCK
REMOTE
GEN LOCK
CCDC-5/10/25/50A/100A cable
DXC-950P
DC IN/
MENU FUNCTION DATA
FLASH UP LENS
WHITE
BARS
DOWN
REMOTE
CCU
RGB/SYNC
VIDEO OUT REMOTE
DC IN/ GEN LOCK
REMOTE
GEN LOCK
CCDC-5/10/25/50A/100A cable
CMA-D2CE/D2MDCE camera adaptor
1
Set the MODE selector
to the "1" position.
2
CAMERA (4-pin)
AC outlet
CMA-D2CE/D2MDCE camera adaptor
Set the MODE selector
1
to the "1" position.
2
CAMERA (4-pin)
Power
cord
AC IN