Connections For A Multi-Camera System - Sony DXC-950 Mode D'emploi

Connections for a Multi-Camera System

Notes on multi-camera systems
Take the following steps to prevent flicker when switching
between two or more cameras connected to a video switcher:
• Supply the same sync signal to the GEN LOCK
connectors on each camera (see below).
Sync signal
generator or camera
Sync (VBS or
BS) output
VIDEO IN
Video switcher, etc.
VBS (BS) OUT
Video monitor, VCR, etc.
DXC-950
MENU FUNCTION DATA
FLASH
BARS
RGB/SYNC
VIDEO OUT
DC IN/
REMOTE
VIDEO OUT
75Ω coaxial cable
VBS (BS) OUT
DXC-950
MENU FUNCTION DATA
FLASH
BARS
RGB/SYNC
VIDEO OUT
DC IN/
REMOTE
VIDEO IN
VIDEO OUT
75Ω coaxial cable
CCDC-5/10/25/50A/100A cable
• Adjust the subcarrier and horizontal synchronization
phases for all cameras.
For more details, see "Adjusting the Picture Tone in a
Multi-Camera System" on page 105.
DC IN/
UP LENS
WHITE
DOWN
REMOTE
CCU
REMOTE
GEN LOCK
GEN LOCK
CCDC-5/10/25/50A/100A cable
DC IN/
UP LENS
WHITE
DOWN
REMOTE
CCU
REMOTE
GEN LOCK
GEN LOCK
CMA-D2 camera adaptor
1
Set the MODE selector
to the "1" position.
2
CAMERA (4-pin)
AC outlet
CMA-D2 camera adaptor
Set the MODE selector
1
to the "1" position.
2
CAMERA (4-pin) AC IN
Power
cord
77