Connecting To Video Equipment With Rgb Or S-Video Inputs - Sony DXC-950P Mode D'emploi

Connecting to Video Equipment With RGB or S-Video Inputs

Camera cable: CCXC-9DB (D-sub 9-pin Nn BNC connectors), or
CCMC-9DS (D-sub 9-pin Nn BNC, S-video connectors)
DXC-950P
MENU FUNCTION DATA 
FLASH
UP LENS
WHITE
BARS

DOWN
CCU
RGB/SYNC


VIDEO OUT REMOTE
DC IN/ GEN LOCK
REMOTE

DC IN/
CCDC-5/10/25/50A/100A cable or
CCMC-12P02/05/10/25 cable
If a CCMC cable is used, the S-video signal is also
output from the S-video output of the CMA-D2CE/
D2MDCE.
Note
Before connecting video equipment, see "Important safeguards/notices for use in the medical environments" on page 5.
a) When using a video monitor without a sync signal input
connector, the camera can be set to output a sync signal with the
G signal (G.SYNC).
For details, see page 44.
RGB/SYNC
or
Camera cable CCXC-9DD (D-
sub 9-pin Nn D-sub 9 pin)
REMOTE
Sync input
Composite video (BNC) or
S-video input (4-pin)
1
Set the MODE selector
CMA-D2CE/D2MDCE
to the "1" position.
2
camera adaptor
CAMERA (4-pin) connector
b) This setup is for connecting to a composite video (VBS)
connector. To send separated Y/C signals to the S-video input of
video equipment, use a CCMC-9DS camera cable.
For details on switching camera output between VBS
(composite video) and Y/C, see page 45.
R input
RGB monitor, image
G input
processor, etc.
B input
a)
b)
RGB/SYNC
Computer, image
processor etc.
Power
cord
AC IN
23