Preparation; During Operation - Castelgarden 85C Manuel D'utilisation

(Translation of the Original Instructions)
The operator of a machine must care-
fully follow the driving instructions, par-
ticularly:
a. the need for care and concentration when
using machines;
b. that control of a machine sliding on a slope
will not be regained by the application of the
brake. The main cause behind a loss of ma-
chine control are:
• insufficient wheel grip;
• being driven too fast;
• inadequate braking;
• the type of machine is unsuitable for its
task;
• lack of awareness of the effect of ground
conditions, especially slopes;
• Incorrect use of the machine as a towing
vehicle;
The machine is equipped with a series
of safety microswitches and devices
which must never be removed, altered
or tampered with. Removing these de-
vices invalidates the warranty and the
manufacturer declines any responsi-
bility. Always check the safety devices
work before using the machine.
3.2

PREPARATION

• When using the machine always wear sturdy,
slip-resistant footwear and long trousers.
• Never activate the machine when barefoot or
wearing open-toe sandals.
• Do not wear chains, bracelets, cumbersome
clothing with strings or ties.
• Tie back long hair. Always wear hearing
protectors.
• Thoroughly inspect the area where the
equipment is to be used and remove all objects
which may be thrown by the machine (stones,
sticks, metal wire, bones, etc.)
CAUTION: DANGER! Petrol is highly in-
flammable.
a. store fuel in containers specifically designed
for this purpose;
b. refuel using a funnel and outdoors only.
Do not smoke while refuelling or whenever
handling the fuel;
c. add fuel before starting the engine. Never
remove the cap of the fuel tank or add fuel
ENGLISH
while the engine is running or when the en-
gine is hot;
d. if fuel is spilled, do not attempt to start the
engine but move the machine away from
the area of spillage and avoid creating any
source of ignition until the fuel has evapora-
ted and the fumes dispersed;
e. replace caps of all fuel tanks and containers
securely.
Replace faulty silencers.
Before using, always carry out a visual
inspection, particularly of the cutter
blade, seeing that the screws and cutter
deck assembly are not worn or dama-
ged.
Replace a worn or damaged cutter bla-
de and screws as a set to preserve ba-
lance.
Any repair shall be performed by an au-
thorized service centre.
Check the condition of the battery at
frequent intervals. Replace if damages
to the casing, cover or terminals are
found.
3.3

DURING OPERATION

Never start the engine in a confined
area where hazardous carbon monoxi-
de gases can build up. All starting ope-
rations have to be effected in an open
or well ventilated area! ALWAYS RE-
MEMBER THAT EXHAUST GASES ARE
TOXIC!
Mow only in daylight or with good artifi-
cial light in good visibility conditions.
Keep persons, children and animals
away from the working area.
If possible, avoid working on wet grass.
Do not work under rain or thunder-
storms.
Do not use the machine in bad weather,
especially if there is a risk of lightning.
Before starting the engine, disengage
the cutter blade or the PTO and put the
gear into neutral.
EN
5