Table des Matières
Publicité
EN
Check the cutting blade's balance after
sharpening. All operations concerning
the cutting deck assy (disassembling,
sharpening, balancing,
and/or replacement) are tough works
and require a specific knowledge as
well as special tools; for sake of safety,
they should always be performed by an
authorized service centre.
• Regularly check the brakes work properly. It is
important to service the brakes and repair them
if necessary.
• Frequently check the grass collector for wear
and damage.
• Replace any damaged warning and instruction
stickers.
• If the machine has no mechanical stoppers for
transport, accessories must always be resting
on the ground when the machine is parked,
stored or left unattended.
• Store the machine where children cannot get
to it.
Never store the equipment with fuel
in the tank inside a building where fu-
mes may reach a flame or a spark or a
source of extreme heat.
• Allow the engine to cool before storing in an
enclosed space.
• To reduce the fire hazard, keep the engine,
exhaust silencer, battery compartment and fuel
storage area free of grass, leaves, or excessive
grease.
• To reduce the risk of fire, regularly check the
machine for oil and/or fuel leaks.
• If the fuel tank has to be drained, this should be
done outdoors and when the engine is cool.
• The ignition key must never be left inserted in
the machine, or where children or persons not
familiar to the machine may reach it. Before any
maintenance or repair, remove the ignition key.
CAUTION! – Battery acid is corrosive.
In the event of mechanical damage or
overcharging, acid may leak out. Avoid
inhalation or contact with any part of
the body.
Inhaled acid fumes are harmful to mu-
cous membranes and other internal
organs. Seek medical attention imme-
diately.
8
ENGLISH
assembling
3.5
3.6
• Safeguarding the environment must be a
• Adhere strictly to the local regulations governing
• Adhere strictly to local regulations governing the
(Translation of the Original Instructions)
CAUTION! – Do not overcharge the bat-
tery. Excessive charging may cause the
battery to explode with subsequent
acid leaks.
CAUTION! – Acid can seriously damage
tools, clothing and other materials. Rin-
se away spilled acid immediately with
water.
Do not short circuit the battery termi-
nals. Sparks occur which can result in
fire.
TAKE CARE over the hydraulic compo-
nents. Pressurized hydraulic fluid leaks
may lead to injection injuries which can
seriously damage tissues and need im-
mediate medical attention.
TRANSPORTING
CAUTION! - If the machine is transpor-
ted on a truck or trailer, use ramps with
suitable resistance, width and length.
Load the machine with the engine
switched off, without a driver and
pushed by an adequate number of pe-
ople.
During
transport,
stopcock (if fitted), lower the cutting
deck assy or the accessory, engage the
parking brake and fasten the machine
securely with ropes or chains to the
hauling device.
ENVIRONMENTAL PROTECTION
relevant and priority aspect of machine use, of
benefit to the community and the environment
we live in. Avoid being a disturbance to the
neighbourhood.
the disposal of packaging, oil, fuel, filters,
damaged parts or any other element which may
have an impact on the environment; this waste
should not be disposed of along with standard
household waste, but must be disposed of
separately and sent to special waste disposal
facilities for handling and recycling.
disposal of cuttings.
close
the
fuel
Publicité
Table des Matières
