Table des Matières
Publicité
EN
7.2.1 Basic adjustment
When the cutting-means assembly is in the basic
setting, the best mulching effect and good disper-
sion of the cut grass are achieved.
The basic setting is recommended for grass of a
normal length. See 5.4.
7.2.2 Greater tilt
If the cutting-means assembly is tilted forward, the
mulching effect is reduced, improving the disper-
sion of cut grass.
It is advisable to tilt the cutting-means assembly
forward when tackling thick grass.
7.3
MOWING TIPS
To get the best mowing results, follow the tips
given below.
• Cut grass frequently.
• Run the machine at full revs.
• Grass should not be wet.
• Only use sharp cutting devices.
• Keep the bottom side of the cutting device
clean.
7.4
COMPOSTING / REAR DISCHARGE
Grass can be cut in two ways.
• Composting the grass on the lawn.
• Expulsion of grass from the back of the cutting
mean.
• text
When the machine is delivered the cutting-means
assembly is set for composting.
Expulsion of grass from the back of the cutting-
means assembly.
• Slacken and remove the screw (23:A) which
secures the deflector in place (23:B).
• Remove the deflector (23:B).
Keep the screw and the deflector in a safe place
for future use.
8 MAINTENANCE
8.1
PREPARATION
All service and all maintenance checks
must be carried out on a stationary ma-
chine with the engine switched off.
Always apply the parking brake to stop
the machine from moving. (please refer
to the machine's manual)
12
ENGLISH
(Translation of the Original Instructions)
Turn off the engine. (please refer to the
machine's manual).
Prevent inadvertent start-up of the en-
gine.
For petrol powered machines; discon-
nect the spark plug leads.
For diesel powered machines; discon-
nect the (negative) lead from the bat-
tery.
Remove the key from the ignition. (plea-
se refer to the machine's manual).
Wear protective gloves.
8.2
WASHING POSITION
1. Set the tool lift in the transport position.
2. Set the maximum cutting height.
Follow the indications provided in hea-
ding 3.7.
1. Remove the rear section of the cutting deck
assy as follows:
• Slightly lift the cutting-means assembly
to ease the load on the cotter pin or peg
(4:A).
• Remove the cotter pin or peg (4:A) and
the washer (4:C) on both cutting-means
assembly arms.
It is strictly forbidden to start the engi-
ne when the deck is in the washing po-
sition.
2. Take hold of the front cutting-means assem-
bly edge (24:A) and lift. Hook-up the chain
(24:B) so that the cutting-means assembly is
pointing upwards diagonally.
3. Clean the cutting-means assembly.
4. Once the washing operation has been
completed, reposition the cutting-means
assembly in its initial position and replace the
washer and cotter pin or peg on both sides.
8.3
MAINTENANCE POSITION
8.3.1 Machine with fixed mounts.
Example of fixed mounts, see (5:C and 6:A).
1. Remove the belt guard as follows:
Park 2WD, 4WD / Castelgarden:
• Slacken and remove the screw (15:A).
Publicité
Table des Matières
