marklin Baureihe 80 Mode D'emploi page 10

Controlling the Locomotive:
1. Select the locomotive from the
locomotive list.
2. Turn the speed control knob to
the right: Locomotive goes faster.
Turn the speed control knob to
the left: Locomotive goes slower.
The speed that has been set can
be recognized by the length of the
bar in the speed display.
Press down on the speed control
knob: Locomotive changes direc-
tion.
Important: The locomotive must
first come to a full stop, before the
direction of travel can be changed.
Important: The direction indicator
in the display changes when the
locomotive changes direction.
2.3.2 Digital Locomotive Operation
with the 6021 Control Unit
Requirement: The 4 coding switches
on the back of the Control Unit must
be set as follows.
Switch: 1 2 3
Setting: Off On Off
or
Switch: 1 2 3
Setting: On On On
Controlling the Locomotive:
1. Enter the locomotive address
(80 as set at the factory).
2. Adjust the speed with the speed
control knob.
Turn to the right (maximum to the
stop): Locomotive goes faster.
Turn to the left (maximum to the
"0" position): Locomotive goes
slower.
3. To reverse the locomotive, turn the
speed control knob to the left past
the "0" position.
Important: The locomotive must
4
first come to a full stop, before the
Off
direction of travel can be changed.
Tip: Note the direction indicator on
the Control Unit or on a Control 80 f
locomotive controller connected
4
to the Control Unit.
Off
4. Controlling auxiliary functions:
Pressing the "function" button:
Headlights are turned on.
Pressing the "off" button:
Headlights are turned off.
Pressing the "f2" button:
Sound effect of a bell is turned on
or off, depending on whether it is
already on or off.
2
Operation
Pressing the "f3" button:
Sound effect of a horn is turned on
or off, depending on whether it is
already on or off.
Pressing the "f4" button:
Locomotive operating sounds are
turned on or off, depending on
whether they are already on or off.
2.3.3 Operating with the
6607 Delta Station 6607
and a 6608 Delta Mobil
Locomotive Controller.
Requirement: One of the following
locomotive addresses must be set
in the locomotive.
Delta Address 1 2 3
Corresponds 78 72 60 24
to Locomotive
Addresses
4
11