Machine Description - Blakeslee RC-62-3 DR24 Notice D'installation, D'emploi Et D'entretien

2. MACHINE DESCRIPTION

2.1 Machine description
Refer to annexes for the technical data of the machines.
G
H
Example:
MACHINE IN RIGHT EXECUTION
A - SPLASH GUARD
B - WASH + RINSE
C - PRE-WASH + WASH + RINSE
D - CONTROL PANEL
G - EMERGENCY BUTTON
L - WALL-MOUNTED CIRCUIT BOARD
A - SPLASH GUARD
B - WASH + RINSE
C - PRE-WASH + WASH + RINSE
D - CONTROL PANEL
This machine is built with high quality materials in particular AISI 304 stainless steel (AISI 316 for boilers and tanks) and in
high thickness to ensure a longer lifetime.
The machine is built in diff erent sections:
Pre-wash module (the presence depends on the model chosen):
temperature thermostatically controlled to melt the alimentary residuals and avoid the proteins denaturation.
Wash module: a proper washing of the crockery is performed with temperature thermostatically controlled.
Rinse module: a pre-rinse is performed that removes most of the detergent, then a fi nal rinse is performed with high
temperature thermostatically controlled.
Autotimer: the Autotimer function (activated by default) allows stopping the machine if it is in start-mode but not operating
at the moment.
It can happen in two cases:
1. The machine is working in vain (it is in operation but it is not used).
2. The machine is in operation but a baskets accumulation exiting the machine causes the limit switch SQ1 to trip (F1).
In these cases, the timer set by default at 300 seconds trips. When the time is over the energetic saving mode turns on.
By inserting a basket or clearing the exit the machine restarts automatically to operate.
D
pict. 4
B
Module
G D
H
A
Width
6" (150 mm)
42 ½" (1080 mm) 56
62" (1580 mm)
33 ½" (850 mm) 68
a preliminary rough washing is carried out with low
A
C
Dimension
Height Depth
/ " (1425 mm)
1
8
28" (720 mm)
/ "(1735 mm)
3
8
USA
page 41