Storing A Specified Destination In The Destination Memory - JVC KD-NX1R Manuel D'instructions

Navigation operation
See "Dynamic navigation with TMC" on page 97 for fur-
ther information.
•
Provides options for avoiding motorways, ferries or toll
roads.
Selection can be made by turning the right rotary control,
and settings can be changed by pressing the right rotary
control .
Press the control for more than 2 seconds to accept all set-
tings and quit the menu.
Note: Routes without motorways can only be calculated
for short distances (up to 200 km).
90
Storing a specified destination in the destination
memory
It is not absolutely necessary to store a destination in the des-
tination memory for route guidance. It saves repeated manual
entry, if the destination is required at a later date.
Select
right rotary control to confirm.
Any name of your choice consisting of up to 20 characters can
be entered for the specified destination and then automatically
stored in the destination memory after pressing the right rota-
ry control for more than 2 seconds. See "Destination mem-
ory" on page 103.
To store, the small tick can also be selected and the right
rotary control briefly pressed.
If you do not wish to enter a name of your choice, press and
hold the right rotary control
store the address as previously entered in the destination
memory.
The last destination entered can be filed at any position by
turning the right rotary control
confirmed by briefly pressing the right rotary control
A total of 50 destinations can be stored.
in the route menu and press the
for more than 2 seconds to
. The memory position is
.