Setting the fader
Press the
button and then the multifunction button
.
Use the right rotary control
Setting the balance
Press the
button and then the multifunction button
.
Set the desired balance level using the right rotary control
Linear setting
Briefly press the
button.
for the desired fader setting.
Press the multifunction button
played. By pressing the multifunction button
tone settings for the currently selected signal source (e.g. FM)
are set to an average value.
Setting the subwoofer or centre speaker volume
Press the multifunction button
Use the right rotary control
volume level.
Switching loudness on/off
Press the
button and then the multifunction button
.
.
Using the multifunction button
loudness on (
) or loudness off (
Loudness is switched off in MW, LW and SW wavebands.
General operation
-
is dis-
again the
.
to set the desired subwoofer
you can select either
).
79