Lumie Bodyclock Classic 150 Notice D'utilisation page 5

BCCI0807:Layout 1 3/7/08 11:30
English
9 Using the Bodyclock as a reading light
Press + until the light is as bright as you want it.
Press – to dim or switch off the light completely.
10 Problem solving
Replacement bulbs are available from Lumie.
I ran a test sunrise but the light came up really quickly.
When setting a test alarm make sure you allow enough time for a
full sunrise - the default sunrise takes 30 minutes. For example, if the
actual time is 11:00 the alarm time must be set no earlier than 11:30,
otherwise the sunrise speeds up in order to finish on time.
The light will not come on but the clock still works.
Check to make sure the bulb is fully screwed into the socket. If this
doesn't work, try replacing the bulb.
Neither the clock nor the light works, or the clock is not doing
what I expect it to.
Unplug the Bodyclock, wait several seconds (count to 10) then plug
it back in. Sometimes the microprocessor picks up static electricity
and unplugging it removes the static. If this doesn't work, check the
fuse in the plug.
Please call the Lumie Careline (01954 780500) if you have any other
problems.
8 | www.lumie.com
Page 8
English
Warranty
This unit is covered under warranty against any manufacturing
defect for 24 months from the date of purchase. This is in addition to
your statutory rights. If you are returning the unit for service, it must
be in its complete original packaging including internal pieces.
Make sure that the mains plug is prevented from moving in transit
and damaging the unit. If the unit is received damaged or without
original packaging, then we may have to charge to put it right.
Please call us for advice before sending the unit back.
Technical specification
Specification subject to change without notice.
Lumie Bodyclock Classic 150
230Vac 50Hz 70W
Lamp E14 (SES) 35mm candle 230V 40W MAX
Operating temperature 0˚C – 35˚C
Class I Medical Device
www.lumie.com | 9