Luminance Brands Kathy Ireland Home HIGHPOINTE LED Manuel Du Propriétaire page 21

7. Disassemble the LED Light Fixture Assembly
for the No-Light Cover Installation Only
7.3
Disengage the Fan Motor Blue Wire Connector from
the LED Light Fixture Assembly Black Wire Connector
(Figure 33).
Disengage the Fan Motor White Wire Connector from
the LED Light Fixture Assembly White Wire Connector
(Figure 33).
NOTE: Store the LED Light Fixture Assembly in a
safe place for future use, if needed.
7.4
Carefully tuck the Fan Motor Wire Connectors up close
into the Lower Housing (Figure 34).
Place the No-Light Cover onto the Lower Housing aligning
the three flat areas on the top flange of the No-Light Cover
with the three dimples on the inside of the Lower Housing
(Figure 34).
Then turn the No-Light Cover clockwise until it stops
turning.
Your No-Light Cover is now installed.
WARNING
!
To avoid possible fire or shock, make sure that the
electrical connector are completely tucked inside the
lower housing and not pinched by the no-light cover.
FAN MOTOR
BLUE WIRE CONNECTOR
FAN MOTOR
WHITE WIRE CONNECTOR
LED LIGHT FIXTURE
ASSEMBLY
WHITE WIRE CONNECTOR
LED LIGHT FIXTURE
ASSEMBLY
BLACK WIRE CONNECTOR
LED LIGHT FIXTURE
ASSEMBLY
Figure 33
FLAT
AREA
Figure 34
21
(Continued)
DIMPLES
(3)
LOWER
HOUSING
NO-LIGHT
COVER
luminancebrands.com
Please contact 1-800-777-4440 for further assistance
U.L. Model No.: CF205L-1