Luminance Brands Kathy Ireland Home HIGHPOINTE LED Manuel Du Propriétaire page 7

3. Ceiling Fan Assembly
3.8
Align the Clevis Pin holes in the Downrod with the holes
in the Motor Coupler.
Install the Clevis Pin and secure with the Hairpin Clip
(Figure 7).
The Clevis Pin must go through the holes in the Motor
Coupler. It is critical that the Clevis Pin in the Motor
Coupler is properly installed and securely tightened.
Retighten the Two Phillips Head Set Screws to secure
the Downrod to the Motor Coupler (Figure 7).
WARNING
!
It is critical that the clevis pin and setscrews in the
motor coupler are properly installed and securely
tightened. Failure to verify that the pin and setscrews
are properly installed could result in the fan falling.
3.9
Make sure the Grommet is properly installed in the
Coupler Cover, then slide the Coupler Cover on the
Downrod until it rests on the Motor Housing (Figure 8).
3.10
NOTE: If you installed the 6" Downrod, the three
Decorative Rod Assemblies and the Rod Support
Assembly will not be installed. Disregard Steps 3.10
through 3.12; proceed to Step 3.13.
Make sure the Grommet is properly installed in the Rod
Support Assembly. Slide the Rod Support Assembly onto
the 12" Downrod (Figure 9).
Then position the three screws in the Rod Support
Assembly toward the top (Figure 9).
(Continued)
HAIRPIN
CLIP
CLEVIS
PIN
CLEVIS
PIN
RETIGHTEN
PHILLIPS HEAD
SET SCREW (2)
Figure 7
MOTOR
HOUSING
Figure 8
ROD SUPPORT
ASSEMBLY
Figure 9
7
MOTOR
MOTOR
COUPLING
COUPLER
HAIRPIN
CLIP
GROMMET
COUPLER
COVER
12" DOWNROD
GROMMET
SCREWS (3)
(Toward Top)
COUPLER
COVER
luminancebrands.com
Please contact 1-800-777-4440 for further assistance
U.L. Model No.: CF205L-1