Initial Start-Up; Water Heater Hand Over; Normal Maintenance - Stiebel Eltron MINI 2-1 Mode D'emploi Et Installation

INITIAL START-UP

8. Initial start-up
WARNING: Open hot water faucet for a few minutes until
!
water flow is continuous and all air is purged from water
pipes. The unit's plastic cover must be installed before the circuit
breaker is turned on.
1
9.

Water heater hand over

Explain the functions of the unit to the user and familiarize him or
her with its use.
Important instructions:
» Draw the user's attention to possible hazards (scalding).
» Hand over these instructions for future reference.
™
16 | MINI SERIES TANKLESS ELECTRIC WATER HEATERS
2
» In order to obtain a proper temperature at a single spout
mixer-type faucet, restrict cold water flow to faucet by partially
closing the cold water shut-off valve under the sink until cold
water and hot water flow rates are approximately the same.

10. Normal maintenance

CAUTION: Other than the filter screen, the Mini does not
!
contain any parts serviceable by the lay person. In case
of malfunction please contact a licensed plumber or electrician.
Stiebel Eltron Mini tankless heaters are designed for a very long
service life. Actual life expectancy will vary with water quality
and use. The unit itself does not require any regular maintenance.
However, to ensure consistent water flow, it is recommended to
periodically remove scale and dirt that may build up at the aerator
of the faucet or in the shower head. Also, the Mini has a built in filter
screen that should be cleaned from time to time. In order to do this,
turn off the cold water supply at the isolating valve. Clean screen
and put the screen back into its original position.
WWW.STIEBEL-ELTRON-USA.COM