Every technical change has an
effect on the operation or safety
of the appliance and must there-
fore be performed by technical person-
nel of the manufacturer or by techni-
cians who are formally authorised by
the same. Failure to do so exempts the
manufacturer from any liability for for
any possible resulting modifications or
damage.
Upon arrival, check the integrity
of the appliance and its compo-
nents (e.g. power cord), prior to use. In
the presence of faults do not start the
appliance and contact the nearest ser-
vice centre.
Read the instructions before
acting.
be performed. As far as personal pro-
tective equipment is concerned, the
European Community has issued Di-
rectives which the operators must
comply with. Noise ≤ 70 dB.
It is forbidden the installation
of stand alone equipment WI-
THOUT anti-tip kit (ACCES-
SORY). TOP versions excluded.
For stand alone installation
of the cooking equipment, it
is mandatory to assemble the
supplied anti-tip kit
Before making the connections
check the technical data shown
on the rating plate of the applian-
ce and the technical data in this ma-
nual. It is strictly forbidden to tamper
with or remove the plates and picto-
grams applied to the equipment.
Disconnect all supplies, if pres-
ent (e.g. water - gas - electrical)
upstream the appliance whenev-
er you need to work in safe conditions.
THE PRESENT MANUAL IS PROPERTY OF THE MANUFACTURER. ANY REPRODUCTION, EVEN PARTIAL, IS PROHIBITED.
GENERAL AND SAFETY INFORMATION
Wear
protective
equipment suitable
for the operations to
- 5 -
Connect the appliance if pre-
sent, in the sequence of the wa-
ter, then to the gas network. Ensure
there are no leaks then proceed with
the connections to the mains.
The appliance is not designed to
work in an explosive atmosphe-
re and as such its installation
and use is categorically prohibited in
such environments.
Position the entire structure, re-
specting the installation dimen-
sions and characteristics indica-
ted in the specific chapters of this
manual.
The appliance is not intended for
recessed installation. / The ap-
pliance must be used in a well
ventilated area. / The appliance must
have free drainage (not hindered or im-
peded by foreign bodies).
The gas equipment must be in-
stalled beneath an extraction
hood whose system must have
specifications in compliance with the
current regulations in the country of use.
Once the appliance is connect-
ed to the power and drain sourc-
es, it must remain static (fixed) in
the place of use and maintenance. In-
correct connection may cause danger.
Use where appropriate flexible
cable for connection to the mains
electricity supply with characteri-
stics not inferior to the model H07RN-F.
The supply voltage supported by the
cable with the appliance working must
not differ from the nominal voltage va-
lue ± 15% shown at the bottom of the
technical data table.
The appliance must be included
in an "Equipotential" ground dis-
charge system.
Drainage of the appliance must
2.
EN