Operation - Blumfeldt Heat Guard Reflex Mode D'emploi

EN
20

OPERATION

Control Panel and Remote Control
1
Remote control receiver
2 Heating indicator light
Note: The distance between the heater and the remote control should be
less than 3 m
Set the heater in heating status
• Connector the heater to a power outlet.
• Press the main power Switch to the position of I, point the remote control
to the receiver, and press button "ON" on the remote control, the heater
starts to heat.
• Point the remote control to the receiver, Press the key "off", the heater
reverts to standby mode, the heating indicator light will flash.
• When the unit is in standby mode, point the remote control to the receiver.
Press the key "on", the unit starts heat.
5
Timer indicator light
6 Main power switch