Operation; Cleaning And Care - Blumfeldt Guru Plus In&Out Mode D'emploi

OPERATION

1 Insert the plug into the socket.
2 Set the power switch to the ON position. The [-] symbol in the display
starts blinking and the unit is in standby mode.
3 Press the MODE button on the control panel or the remote control several
times to increase the radiant heater output in the following sequence:
Level 1 > Level 2 > Level 3 The set power level is shown in the display.
4 Press TIMER +/- to set the off timer between 0-9 hours. Setting [0] means
that the timer is off.
Note: If you have set power and timer, the display will alternate between
the power and timer settings. The power will be faded in for 10 seconds, the
timer is faded in for 5 seconds.
5 To put the unit back into standby mode, press the OFF button on the
control panel or remote control.
6 To turn off the unit completely, set the power switch to the OFF position.

CLEANING AND CARE

• Before cleaning, remove the plug from the socket and allow the unit to
cool completely.
• Do not use scouring agents or solvents for cleaning and never immerse the
unit in water.
• Clean the outside with a soft, damp cloth.
• The device contains parts that are not accessible to the user. Repairs may
only be carried out by qualified specialists.
EN
13