Use And Operation - Blumfeldt 10032338 Mode D'emploi

USE AND OPERATION

This product is infrared radiant heater with remote control and IP 65
approved. It is almost unlimited used in outdoor ,such as open bars, courtyard,
plaza, station, and construction site in winter . This patio heater is energy-
efficient and environmentally friendly.
Before first Use
• Remove all package material (including anti-vibration object of the lamp)
and check the appliance, supply cord and the plug for signs of damage.
• Pay attention to the mounting place and all mounting material(dowels,
screws). Ensure they are suitable and stable enough for mounting and
lastingly holding of the appliance.
• Before mounting, the minimum safe mounting distances and tilt angles
shown in the figures (on the next page) must be strictly followed.
• The distance between the bottom edge of the appliance and the floor must
be at least 1.8 m (see figure 2 on the next page).
• There must be a distance of at least 0.25 m between the appliance and the
ceilings, roofs or other covers (see figure 2 on the next page).
• There must be a distance of at least 0.5 m at each side between the
appliance and walls or the like (see figure 2 on the next page).
• Recommended degree to mounting surface is 45° (see figure 3 on the next
page).
• Pay attention that, the installation of the appliance must not add excessive
wind load.
• Fix the mounting bracket to the ceiling I first. Ensure that the place to be
installed is secure and firm. Or connect the appliance to the stand.
• Adjust the desired angle of radiation and fest screw all screws. Check
regularly the screw's connection. Mechanical bearing pressure and
oscillation due to wind or rain could lead to loose.
• Plug in the power source and operate the remote control. Then observe,
whether during the first 10-15 minutes the appliance works trouble-free.
• If you do not use, please remove battery socket.
EN
19