Burkert 2001 Notice D'utilisation page 6

Angle-Seat Valve
Carefully read the installation and operating
instructions. Attention must be paid to the
application conditions and the technical data as
specified in the data sheet. Complying with
these instructions will ensure perfect operation
and a long service life.
Application and operation of the device must
ensue according to the general terms of
technology. Appropriate measures must be
taken to avoid unintended operation or
unapproved impairment.
Valve design
2/2-way piston-operated valve,
control function A (normally closed spring
return), B (normally open spring return) or I (with
double-acting actuator).
Actuat. Body Material
Gunmetal Stainless
A PPS PPS
E PPS PPS
Fluid
Gases and liquids that do not corrode the body
and seal materials (gunmetal, stainless steel)
and the PPS material of the fittings.
Attention must be paid to the admissible
pressure ranges and fluid temperatures as
specified on the data sheet or the type label.
Control fluid
– neutral gases and air
Temperature range:
Actuat. Fluid *1
[ºC]
A/E -10 to +100
*1
specifications are valid for PTFE seat seals.
*2
max. + 55 ºC with pilot valve.
6
Installation
The applicable safety regulations must be
observed.
! Pipelines must be contamination-free.
• Installation as required, but preferably with
actuator upright. Observe flow direction.
• Connect valve. Observe aligned pipes.
– For stainless steel bodies with welding
– For bodies with connection thread the
References for remove and assembly of
actuator
• Befor remove or assembly of actuator must be
relieve the valve seat, that is
Actuator Conect.
– by SFA change the actuator or relax the
PA Brass
– by SFB and SFI stop the control fluid supply.
PA 1.4305
• Unscrew actuator on nipple from valve body.
• Only by Stainless steel body: Grease over
nipple thread with „GLEITMO 810".
• Screw nipple and actuator into valve body.
• Connecting the control fluid for
control function:
– A, to the lower
– B, to the upper
actuator port with G 1/4" thread.
(Connection can be rotated by 360º).
The Pilot valve must be connected to the
actuator with a hollow screw (Types 6012 P,
6014 P) and the control fluid must be connected
to port P of the pilot valve.
Repair
Ambient *2
Stop fluid supply and control fluid supply and
[ºC]
reduce pressure in the pipe system, before the
-10 to +60
device can be opened or repaired.
connection actuator must be removed befor
welding.
actuator only must be removed by
especially desire of customer.
spring across opening the top of actuator