Installing Mini Heki Style - Dometic Mini Heki Style Instructions De Montage Et De Service

Mini Heki Style
7

Installing Mini Heki Style

Supplementary to fig. 4
The scope of delivery contains a mounting frame, which is suitable for roof
thicknesses of 25 – 42 mm or 43 – 60 mm.
➤ Measure your roof thickness W.
➤ Shorten the sleeves to size H (see table).
➤ Use the screws with appropriate lengths (see table).
Siehe fig. 5
➤ Check that the roof light has sufficient space around (approx. 1 to 2 mm) it in the
roof opening.
See fig. 6
➤ Clean the roof opening in the mounting area.
See fig. 7
A
NOTICE!
Observe the instructions of the sealant manufacturer.
➤ Seal the mounting frame with a flexible non-hardening sealing compound (e.g.
SikaLastomer-710).
See fig. 8
➤ Observe the direction of travel when installing.
➤ Place the outer frame in the middle of the roof opening.
➤ Press the outer frame in the roof slightly so that the packing compound spreads
out.
See fig. 9
➤ Install the mounting frame.
➤ Tighten the screws 10 minutes after installation.
See fig. 0
➤ Install the fastening clips on the inner frame at the specified distances.
See fig. a
➤ Fit the inner frame into the mounting frame.
EN
Installing Mini Heki Style
7