Power Fist 8598195 Manuel D'utilisateur page 2

8598195
Cutting, Welding and
Brazing Hose Torch
SPECIFICATIONS
Torch Type
Gas Types
Maximum Flame Temperature
Flame Arrestor
Hose Length
Cylinders (not included)
INTRODUCTION
The Cutting, Welding and Brazing Hose Torch attaches to MAPP and Oxygen
cylinders (sold separately). The flame generated can be used for soldering, heat
treatment, cutting, brazing or welding.
Consult the safety and use instructions for the gas cylinders before using this torch.
SAFETY
WARNING! Read and understand all instructions before using this tool. The
operator must follow basic precautions to reduce the risk of personal injury
and/or damage to the equipment.
Keep this manual for safety warnings, precautions, operating or inspection and
maintenance instructions.
HAZARD DEFINITIONS
Please familiarize yourself with the hazard notices found in this manual. A notice
is an alert that there is a possibility of property damage, injury or death if certain
instructions are not followed.
2
Cutting, Welding and Brazing Hose Torch
MAPP
Oxygen
Cutting, Welding and Brazing Torch
MAPP® and Oxygen
5,300ºF (2,926ºC)
Yes
44 in.
Yellow, Right-Hand Threads
Red, Left-Hand Threads
For technical questions call 1-800-665-8685
V4.0