Publicité
Les langues disponibles
Les langues disponibles
8598195
REPLACING THE BURNER TIP
WARNING! Do not turn, bend or twist the fuel tube during this procedure.
Doing so will damage the torch and/or flame arrestor. Have the torch
repaired or discard and replace with a new torch. Do not use the damaged
torch, as it is a fire hazard.
1.
Wrap a soft cloth around the cooled fuel tube.
2.
Secure the wrapped fuel tube in a vise with the burner tip exposed. Be
careful not to crimp the hoses or fuel tube.
3.
Twist the burner tip counterclockwise to remove.
4.
Install a new burner tip by turning clockwise carefully to avoid cross
threading. Tighten until it is hand snug. Do not tighten with a tool. No more
than a single full thread should remain exposed.
5.
Remove from the vise and assemble the torch. Check for leaks per
assembly instructions.
STORAGE
Consult the fuel cylinders' instructions on storage requirements.
DISPOSAL
Recycle a tool damaged beyond repair at the appropriate facility.
Contact your local municipality for instructions on recycling or disposing the
fuel cylinders.
16
Cutting, Welding and Brazing Hose Torch
For technical questions call 1-800-665-8685
V4.0
Publicité
