Technical Specifi Cations - Gaggia Milano ANIMA PRESTIGE Mode D'emploi

Problem
The milk does not con-
tain froth.
The "INTENZA+" fi lter
icon is shown on the
display after the fi lter has
been replaced.
The "INTENZA+" fi lter
cannot be inserted.
There some water under
the machine.

Technical specifi cations

HOUSING MATERIAL
SIZE
WEIGHT
POWER CORD LENGTH
CONTROL PANEL
CUP SIZE
WATER TANK
COFFEE BEAN HOPPER CAPACITY
COFFEE GROUNDS DRAWER CAPACITY
PUMP PRESSURE
BOILER
SAFETY DEVICES
Cause
The milk carafe is dirty or it has not
been inserted correctly.
The milk dispensing spout is com-
pletely open.
The milk carafe has not been mount-
ed with all its parts.
The type of milk does not produce
froth.
The RESET has not been confi rmed
through the machine menu.
Remove air from the fi lter.
The tank still contains some water.
You have tried to install a fi lter other
than "INTENZA+" fi lter.
The rubber O-ring is not connected
to the "INTENZA+" fi lter.
The drip tray is too full and has
spilled over.
The machine has not been placed on
a horizontal surface.
Solution
Clean the carafe and ensure to place and insert
it correctly.
Check that the milk dispensing spout is in its
right position.
Ensure that all components (especially the milk
tube) have been correctly mounted.
The amount and the quality of froth vary de-
pending on the type of milk. We have tested the
following types of milk and obtained satisfying
results of froth: semi-skimmed or whole cow's
milk, soy milk and lactose-free milk. We have
not tested other types of milk because they may
produce a scarce amount of froth.
Confi rm the activation of the fi lter using the
machine menu (see "Enabling the "INTENZA+"
fi lter").
Let air bubble fl ow out from the fi lter.
Empty the water tank before installing the fi lter.
"INTENZA+" fi lter is the only one that can be
inserted into the machine.
Check the O-ring packaging and connect it to the
"INTENZA+" fi lter.
Empty the drip tray when the indicator appears
though the tray. Always empty the drip tray
before starting the descaling procedure.
Place the machine on a horizontal surface so as
that the "drip tray full" indicator works correctly.
THERMOPLASTIC MATERIAL
221 x 340 x 430 mm
7.5 kg
1200 mm
FRONT PANEL
UP TO 152 mm
1.8 litres - Removable type
250 g
15
15 bar
Inox Boiler
Thermal Fuse
English
33