Table des Matières
Publicité
A
d
Make sure the fan is working correctly
when switching on the unit.
Mains voltage.
- Check the conformity of the power supply unit.
Rating plate 11 : Lamp power.
Lighting unit / Power supply connection.
- Connect the lighting unit's power cable B by passing it
inside the yoke.
- Leave a little slack and then block the cable B into the lock d .
- Place the lamp into position - refer to section A - 7.
- Connect the cable 2 to the mains.
CAUTION - For your security !
- Never open the lamp house's bonnet when the
lighting unit is on.
- Do not change the safety switches.
- Never connect to a dimmable channel.
- Use only when the lamp is in place.
robert juliat
Route de Beaumont F 60530 Fresnoy-en-Thelle - phone: 33 (0)3.44.26.51.89 - fax: 33 (0)3.44.26.90.79 - www.robertjuliat.fr
TECHNICAL FILE
1200W HMI FOLLOW SPOTS
CONNECTIONS.
B
C
DESCRIPTION.
A
1200W Hot restrike follow spot.
B
Cable 7x4AWG 19G 12mm
with 16 x 16A male HARTING connector.
C
Power supply unit.
1 - EF HARTING 16 x 16A - 2 latch connector.
2 - Mains cable.
3 - Time meter.
4 - General 16A circuit breaker (208/245V).
- General 25A circuit breaker (110V).
5 - Mains, checklight.
6 - 1A automatic breaker.
7 - "ON/OFF" switch.
8 - "Wieland" 2 point connector : remote control.
9 - Lamp ON, checklight.
If the lamp's checklight is OFF when the switch is
ON; the lighting of the lamp has failed.
Repeat the operation - refer to section A - 7.
10 & 11 - Rating plate.
1149 & 1449 /
Section A - 5
C
3
30.23
7
5
AMONT
ON
6
MAINS
FUSE
4
TELECOMMANDE /
REMOTE CONTROL
0 - OFF
0 - OFF
0 - OFF
2
Power supply unit
(P.S.U.)
Lighting unit's power cable.
, length 3m equipped
2
B, C & CB
8
9
LAMP ON
OFF
1
10
HMI 1200
220/240V 50Hz
11
Publicité
Table des Matières
