Table des Matières
Publicité
PLACING THE LAMP.
User's precautions:
- Disconnect from the mains.
- Lamp is cold.
- Avoid touching the bulb of the lamp.
- Open the bonnet and the side trapdoors of the lamp house.
- Use only when lamp is in place
Preparing the lamp:
- Unscrew the nuts 1 without completely taking them off.
INSTALLING THE LAMP :
- Place the lamp into the contacts 2 and
the tip-off in the upper postion D .
- Tighten the nuts 1 firmly, by hand.
Warning : A bad lamp tightening can cause
a bad contact and a defective
ignition. Check regularly that the
nuts 1 are well tightened.
Lamp.
Warning : Do not use a lamp, if the diameter
of the bulb is greater than Ø28mm.
SWITCHING ON.
Warning :
Carry out the connections before
connecting to the mains ( refer to section A - 5).
- No matter what the position of the circuit breaker is 3 , make sure
that the mains checklight 4 is ON.
- Engage the circuit breaker 3 and the automatic breaker 5 .
Control mode - 2 choices:
1 - the "ON / OFF" switch 6 .
2 - an external switch on relay contact (1A - 250V), connected
between two pins on the connector 7 .
! IMPORTANT :
The priority between 6 and 7 is always the ignition - switching OFF
is only possible if 6 and 7 are OFF.
robert juliat
Route de Beaumont F 60530 Fresnoy-en-Thelle - phone: 33 (0)3.44.26.51.89 - fax: 33 (0)3.44.26.90.79 - www.robertjuliat.fr
TECHNICAL FILE
1200W HMI FOLLOW SPOTS
Disconnect from the mains before any servicing.
Service only by qualified technician.
1
1149 & 1449 /
B, C & CB
Section A - 7
A
B
2
B
C
D
1
A
180
C
D
E
2
E
Ø28 maxi
Publicité
Table des Matières
