Electronic Control Setup Instructions (Pd & Pr Models) - Maytag MDE20PDFGW Instructions D'installation

7. Be certain to keep cardboard spacer centered between
doors. Reattach outer door panel to inner door panel so
handle is on the side where hinges were just removed.
8. Reattach screws at top, bottom, and side of door (5 screws).
9. Attach door hinges to dryer door so that larger hole is at
the bottom of the hinge and the hinge pin is toward the
door front.
10. Remove the 4 screws that attach 2 plugs on the left side.
Attach plugs to right side using the same 4 screws.
11. Insert screws into bottom holes on left side of cabinet.
Tighten screws halfway. Position door so large end of door
hinge slot is over screws. Slide door up so screws are in
bottom of slots. Tighten screws. Insert and tighten top
screws in hinges.
12. Close door and check that door strike aligns with door
catch. If needed, slide door catch left or right within slot
to adjust alignment.
20
ELECTRONIC CONTROL SETUP ELECTRONIC CONTROL SETUP
INSTRUCTIONS (PD & PR INSTRUCTIONS (PD & PR
MODELS) MODELS)
IMPORTANT
Electrostatic Discharge (ESD)
Sensitive Electronics
ESD problems are present everywhere. ESD may damage
or weaken the electronic control assembly. The new control
assembly may appear to work well after repair is finished,
but failure may occur at a later date due to ESD stress.
Use an anti-static wrist strap. Connect wrist strap to
■
green ground connection point or unpainted metal in the
appliance.
Touch your finger repeatedly to a green ground connection
point or unpainted metal in the appliance.
Before removing the part from its package, touch the
■
anti-static bag to a green ground connection point or
unpainted metal in the appliance.
Avoid touching electronic parts or terminal contacts;
■
handle electronic control assembly by edges only.
When repackaging failed electronic control assembly
■
in anti-static bag, observe above instructions.
General Information
BLANK DISPLAY – This condition indicates the dryer is
inoperative. Enter set-up mode to view diagnostic code.
"0 MINUTES" SHOWING IN DISPLAY – This indicates the
previous cycle is complete or a machine reset was performed.
Opening the door(s) will restore the display to the Vend Price or
Available state.
Factory Default Settings – Dryer is programmed at the factory
as follows:
PD Models - $1.50 Cycle price for 30 minutes (fixed cycle with
top off).
PR Models - $0.00 Cycle price for 45 minutes (fixed cycle).
WARM START (after power failure) – A few seconds after
power is restored, if a cycle was in progress at the time of the
power failure, "RESELECT CYCLE" will flash in the display,
indicating a button needs to be pressed to restart dryer.
There are four (4) types of dryer pricing:
Fixed "Vend" Pricing
A dryer set up for "Fixed Cycle" operation can only accept
additional time accumulated by increments equal to the length
of a complete dry cycle. A maximum of 75 minutes may be
purchased; no additional credit is given for coins dropped with
75 minutes in the display.
-OR-