Maytag MDE20PDFGW Instructions D'installation page 6

The fresh air ventilation openings into the room and into
■
the dryer must not be blocked or sealed.
Do not reach into the dryer if the drum is moving.
■
Do not open door while dryer is in operation. It will stop.
■
When loading or re-loading the dryer, avoid touching hot
■
metal parts of the drum (burn risk).
Remove all objects from pockets such as lighters and
■
matches.
Cleaning and user maintenance shall not be made by
■
children without supervision.
WARNING: The appliance must not be supplied through
■
an external switching device, such as a timer, or connected
to a circuit that is regularly switched on and off by a utility.
The dryer must not be installed behind a lockable door, a
■
sliding door, or a door with a hinge on the opposite side to
that of the dryer in such a way that full opening of the dryer
door is restricted.
The appliance is intended, but not limited, to be used in
■
public areas.
Children of less than 3 years should be kept away unless
■
continuously supervised.
This appliance incorporates an earth connection for
■
functional purposes only.
IEC Load Capacity - 10.5 kg.
■
Exhaust air must not be discharged into a flue which is
■
used for exhausting fumes from appliances burning gas
or other fuels.
Do not use an unlined masonry chimney as the flue for
■
this appliance.
Only authorized spare parts shall be used in the event of
■
failure.
6
DRYER SAFETY DRYER SAFETY
The design of this dryer has been certified by CSA
■
International for use at altitudes up to 3048 m
(10,000 ft) above sea level at the B.T.U. rating indicated
on the model/serial plate. Burner input adjustments are
not required up to this elevation. For installing above
3048 m (10,000 ft), contact your local qualified service
company.
Emergency stop control: After installation, access to
■
mains plug (gas dryer) or mains supply (electric dryer)
via a double-pole switch must be maintained at all times
in order to ensure immediate deactivation of the dryer in
case of emergency.
The interior of the dryer and dryer exhaust vent should
■
be cleaned periodically by Whirlpool authorized service
personnel.
See "Electrical Requirements" section for earthing
■
instructions.
Adequate ventilation has to be provided to avoid the
■
back-flow of gases into the room from appliances burning
fuels, including open fires.
Oil-affected items can ignite spontaneously, especially
■
when exposed to heat sources such as in a tumbler dryer.
The items become warm, causing an oxidation reaction in
the oil. Oxidation creates heat. If the heat cannot escape,
the items can become hot enough to catch fire. Piling,
stacking or storing oil-affected items can prevent heat
from escaping and so create a fire hazard.
See DIMENSIONS/CLEARANCES section for minimum
■
installation spacing requirements.
This dryer is not fitted with a supply cord and a plug.
■
Means for disconnection from the supply mains having
a contact separation in all poles that provide full
disconnection under over-voltage category III conditions
must be provided, otherwise means for disconnection
must be incorporated in the fixed wiring in accordance
with the wiring rules.
SAVE THESE INSTRUCTIONS